DuPont WFHD13001B Manuel d'instructions télécharger pdf (Page 6)

WFHD13001 Series

V4.0

STEP 5

Hang the Filter System Head

1 Align the System Head A on the pipes so that the inlet and outlet are in the correct locations. The "in" port on the System Head

should be facing the incoming water supply.

2 Allow the System Head to temporarily hang between the two cut plumbing pipes.

3 Apply plumber’s tape or appropriate sealant to the fittings and lines, according to your system configuration.

4 Make all connections and tighten fittings.

NOTE: Keep the Filter System in an upright position.

5 Attach the optional mounting bracket (not included) to the wall using four mounting screws or alternative fasteners (not included).

STEP 6

Hang the Filter Housing

1 Insert the Filter Cartridge C over standpipe in the bottom of the Filter Housing A.

2 Screw the Filter Housing back onto the System Head and hand-tighten. Using the Filter Housing Wrench D, tighten 1/4 turn.

NOTE: Do not over tighten.

A grounding kit (not included) must be installed on water pipes if they are

used to ground electrical systems, appliances or phones.

CAUTION

GROUNDING KIT (NOT INCLUDED)

WATER

FLOW

HOUSE

IN OUT

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Pas de commentaire

DuPont WFHD13001B Manuel d'instructions Page 6